Loading…
Loading…
Home › All recalls › Cars & vehicles
Category
Vehicle recalls — the family car, tyres, equipment.
Or try another category
12,303 recalls · newest first
The brake cylinder on the off-road motorcycle can crack and result in brake failure.
The combination tire inflator and hand pump can shatter under pressure when inflating tires if there is a blockage in the tire valve, posing the risk…
The flange, which holds the fuel pump in the fuel tank, can fail to stay connected to the tank itself.
The recalled ATVs may have a loose fuel valve within the fuel tank, which could cause a fuel leak and pose a fire hazard to riders.
When the engines are primed, excess fuel can overflow into the carburetor and ignite, posing fire and burn hazards to consumers.
The ATV's front bearing carrier can fail due to an insufficient amount of material thickness in the area where the lower a-arm and ball joint are…
The steering posts can break in the area where the handlebar attaches to the steering post.
The seal around the fuel tank can loosen, allowing fuel to leak, posing a fire hazard to consumers.
Liquid rinse-aid can leak from its dispenser onto the dishwasher's internal wiring, which can cause an electrical short and overheating, posing a…
The ATVs lack adequate tire labeling, tire pressure gauge, adequate stop engine switch and other safety requirements, which could result in injury to…
The right and left front suspension shock towers can separate due to inadequate welding during the manufacturing process.
The brake caliper sets could break and detach from the bicycle's fork or frame.
The radius triple clamps on these motorcycles can crack during operation, posing a risk that the fork of the bike could separate and result in…
The airplanes can overheat while recharging the battery, posing a fire hazard.
The bushing pivot mount boss on the left and right suspension arm may not have been welded completely and could break off during riding.
The front suspension arm ball joints could have been contaminated during production, resulting in rapid wear of one or more of the ball joints and…
On the recalled ATVs, the handlebar base mounting bolts, tie-rod ends and tie-rod adjustment locking nuts may not have been tightened to the proper…
On some of these units, the handlebar holder, tie-rod adjustment, and tie-rod end nuts may not have been tightened to the proper torque.
The bicycle's front brake can fail, causing the rider to lose control and fall.
An incorrect burst disc, a component of the NOS bottle valve, may have been installed in the recalled NOS Kits.