Loading…
Loading…
Home › All recalls › Cars & vehicles
Category
Vehicle recalls — the family car, tyres, equipment.
Or try another category
12,297 recalls · newest first
The overheating of the water may result in the release of steam, possibly causing the operator is to scald themselves and increasing the risk of…
The overheating of the water may result in the release of steam, possibly causing the operator is to scald themselves and increasing the risk of…
If the bearings move out of position, the stowed platform may have excessive movement resulting in failure of the platform mounting.
If the bearings move out of position, the stowed platform may have excessive movement resulting in failure of the platform mounting.
If the bearings move out of position, the stowed platform may have excessive movement resulting in failure of the platform mounting.
The gasoline tank vent can become dislodged due to incorrect factory installation and cause fuel to leak, posing a fire hazard.
Without a reflective decal, the stop arms would have reduced visibility to other drivers, increasing the risk of a crash.
If the door latch was not heat treated, in the event of a crash, the door latch may fail allowing the door to open, increasing the risk of injury.
If the parking brake does not fully engage, the vehicle may unexpectedly roll, increasing the risk of personal injury or a crash.
A delay in releasing the brake could cause the brakes to drag and cause premature wear of the brake linings.
Unstable entry and exit steps increase the risk of injury.
If the hex nuts are not tightened to specification, the driveshaft may disconnect from the drive axle, resulting in a loss of propulsion and…
Inappropriate air bag activation/deactivation can increase the risk of occupant injury in the event of a vehicle crash.
In the event of a severe rear-end collision, the seats may tilt rearward and result in injuries to the passenger's knees and/or impede the exiting of…
Higher vehicle speeds and other factors such as tire load and road temperatures may result in premature tire failure, increasing the risk of a crash.
If the operator installs tires that are the size that is indicated on the placard, it can cause poor vehicle handling, increasing the risk of a crash.
If the wires or lines get pinched or scraped, the wires may short or the LP lines may leak.
If the bearings move out of position, the stowed platform may have excessive movement resulting in failure of the platform mounting.
A passenger could be injured if their arm is caught in the door.
If the bolts were not properly tightened, the caliper may detach and reduce braking ability, increasing the risk of a crash.