Loading recalls…
Loading…
Loading…
Home › All recalls › Appliances & tools
Category
Heaters, grills, power tools, batteries, e-bikes, home electronics.
Or try another category
1,404 recalls · newest first
The hair dryers are not equipped with an immersion protection device to prevent electrocution if the hair dryer falls into water.
An electrical failure in the relay, the component that turns on the refrigerator's compressor, can cause overheating and pose a serious fire hazard.
The outer cover of the immersion heater can crack and expose the heating element to water, posing a shock hazard to consumers.
The handlebar stems can crack or break, posing a fall hazard to the consumer.
A tight valve attached to the stove's fuel source can allow gas to leak, posing a fire hazard to consumers.
The suspension system on bikes with the recalled forks could become completely compressed and fail to return to its original position after a…
Gas could flow at a rate that would produce higher than expected flames.
The spokes on the bicycle's front wheel rim can break during use, posing a fall and crash hazard to riders.
If the furnace is not properly wired, the oil burner can continue to operate when the blower shuts off, posing a fire hazard to consumers.
A handle pin on the bicycle trainer can loosen during use, causing the machine to become disengaged, and pose a fall hazard to consumers.
An electrical component in certain model dishwashers can overheat, posing a fire hazard to consumers.
The density of the steerer tubes can cause the forks to crack and break, posing a fall hazard to the consumer.
The return spring on the circular saw's lower blade guard can break, posing a laceration hazard to consumers.
The steel steerer on the forks can crack, causing the fork to detach from the bicycle frame.
Wiring inside the toaster can become loose and contact the toaster body, posing a shock hazard to consumers.
The candle holder placement on the base of the carousels is too close to the structure, allowing the candle flame to come in contact and ignite…
The front bicycle suspension fork can break, causing the rider to crash.
The blower's impeller, which is a rotating component on the blower, can break, resulting in pieces of plastic flying out of the blower.
Delayed ignition due to a build-up of propane gas can cause the insert's glass cover to break, posing a laceration hazard to consumers.
The helmet's chinstrap can unexpectedly disengage while in use.